If possible, use an insulated in-line crimp connector. Test each mended wire with a circuit tester and battery, connected to the nearest connectors either side of the mend. Re-wrap the exposed section of the loom with self-adhesive or "clingfilm" PVC insulating tape. Put some layers between the exposed section and adjoining wires - not merely a cover over the top - then fit the loom back into the car. Reconnect all terminals and clips, then test all the electrical components involved.
STARTER SOLENOID "Relay" — All cars are wired so that the batterys main cable connects to the starter motor windings "the thick cable is needed for large current flow, right?". This wire must be switched on and off, of course, and it would be costly and inefficient to route it through the ignition switch "not to mention the size of the switchs components required to carry such current!". Consequently, a relay is necessary.
Nolanwebdev - Wiring Diagram Images Collection
Copyright © 2003 - 2018 Domain Media. All sponsored products, company names, brand names, trademarks and logos arethe property of their respective owners.