Brushless outrunners are always built on a circuit board. This makes them cheaper. The circuit board for this CD motor has no electronics on it. A ribbon cable attaches 11 wires to another controller circuit board. But often the controller is built onto the same circuit board. The circuit boards interface with a controller in two ways.
2 wires. Servomechanisms are designed to move to a spot and hold it is position. They are not designed to spin continuously. Used to position print heads in ink jet printers, plotters, scanners. Travel at set speeds. Go to a spot and stop. When stopped and still turned on, will attempt to hold it is position. Forcing it to move in this position can damage the motor. Typically is controlled by a circuit board that counts shadows with an LED and light sensor or has a resistor that changes value depending upon position. Often zooms to one side when powered on to figure out where it is at.
Nolanwebdev - Wiring Diagram Images Collection
Copyright © 2003 - 2018 Domain Media. All sponsored products, company names, brand names, trademarks and logos arethe property of their respective owners.